HP ProLiant DL80 Gen9 Maintenance And Service Manual page 67

Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Remove the server from the rack (on page 29).
3.
Place the server on a sturdy, level surface.
4.
If installed, remove the security bezel
5.
Remove the access panel
6.
Remove the air baffle
7.
Release the front I/O cabling from the server:
8.
Detach the ambient thermal sensor cable from its clip.
a.
Disconnect the front I/O assembly cable.
b.
Remove the cable cover behind the right quick-release latch rack ear.
9.
("Remove the security bezel
("Access panel" on page 34).
("Air baffle" on page 35).
(optional)" on page 26).
Removal and replacement procedures 67