HP ProLiant DL80 Gen9 Maintenance And Service Manual page 51

IMPORTANT:
installing the processor.
IMPORTANT:
To remove the component:
Power down the server (on page 26).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Do one of the following:
3.
Extend the server from the rack (on page 27).
o
Remove the server from the rack (on page 29).
o
Remove the access panel
4.
Remove the air baffle
5.
Remove the heatsink ("Heatsink" on page 48).
6.
Open each of the processor locking levers in the order indicated, and then open the processor retaining
7.
bracket.
CAUTION: THE PINS ON THE SYSTEM BOARD ARE VERY FRAGILE AND EASILY DAMAGED. To
avoid damage to the system board, do not touch the processor or the processor socket contacts.
If installing a processor with a faster speed, update the system ROM before
Processor socket 1 must be populated at all times or the server does not function.
("Access panel" on page 34).
("Air baffle" on page 35).
Removal and replacement procedures 51