Front I/O Assembly - HP ProLiant DL80 Gen9 Maintenance And Service Manual

Use a small flat-bladed, nonconductive tool to carefully remove the battery from the socket.
6.
IMPORTANT:
configuration. After replacing the battery, use BIOS/Platform Configuration (RBSU) in the UEFI
System Utilities
To install the component:
Insert the battery with the "+" side facing up underneath the outer lip of the socket, and then press the
1.
battery down to secure it in place.
Install the access panel.
2.
Do one of the following:
3.
Slide the server into the rack.
o
Install the server into the rack.
o
Power up the server.
4.
For more information about battery replacement or proper disposal, contact an authorized reseller or an
authorized service provider.

Front I/O assembly

CAUTION:
precautions before beginning any installation, removal, or replacement procedure. Improper
grounding can cause electrostatic discharge.
To remove the component:
Power down the server (on page 26).
1.
Replacing the system board battery resets the system ROM to its default
("HP UEFI System Utilities" on page 85) to reconfigure the system.
To prevent damage to electrical components, take the appropriate anti-static
Removal and replacement procedures 63