HP ProLiant DL80 Gen9 Maintenance And Service Manual page 42

To remove the component:
Power down the server (on page 26).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Do one of the following:
3.
Extend the server from the rack (on page 27).
o
Remove the server from the rack (on page 29).
o
Remove the access panel
4.
Disconnect the SATA cables from the M.2 SSD enablement board and the system board.
5.
M.2 SSD SATA cable disconnection when the enablement board is installed on the system board
o
M.2 SSD SATA cable disconnection when the enablement board is installed in the FlexibleLOM
o
riser cage
("Access panel" on page 34).
Removal and replacement procedures 42