Changing The Steps In Which The Value Displayed Changes - Toshiba TOSVERT VF-PS1 Instruction Manual

An example of setting: When
Panel indication
Panel indication

6.31.3 Changing the steps in which the value displayed changes

• Function
6
These parameters are used to specify steps in which the command value or standard monitor output
frequency displayed on the panel changes each time you press the up or down key to set a frequency on
the operation panel.
Note: The settings of these parameters have no effect when the free unit selection (
When
Under normal conditions, the panel frequency command value increases in steps of 0.1Hz each time you press the
key. If
press the
In this case, the output frequency displayed in standard monitor mode changes in steps of 0.1Hz, as usual.
When
The value displayed on the panel also can be changed in steps.
Output frequency displayed in standard monitor = Internally output frequency ×
Title
Example of setting 1
Set
Each time you press the
20.0 → ... → 60.0 [Hz]. This function comes in very handy when operating the load at limited frequencies that
change in steps of 1 Hz, 5Hz, 10Hz, and so on.
Example of setting 2
Set
Each time you press the
[Hz] and also the value displayed on the operation panel changes in steps of 1. Use these settings to hide
decimal fractions. And also the value displayed on the operation panel changes in steps of 1. Use these settings
to hide decimal fractions.
= , =
800
0
0
Output frequency
= , =
800
0
0 Output frequency 80 (Hz)
: Changing step selection 1 (pressing a panel key once)
: Change step selection 2 (panel display)
is not
is not 0.00, the frequency command value will increase by the value with
key. Similarly, it will decrease by the value set with
is not
Function
Changing step selection 1
(pressing a panel key once)
Changing step selection 2
(panel display)
= [Hz]:
key, Each time the frequency setting
= [Hz], = :
key, the frequency setting
is , and
Panel indication
1000
200
80(Hz)
, and is (disabled).
, and is not
Adjustment range
. :Disabled
. ~ Hz
:Disabled
~
changes in steps of 1 Hz: 0 → 1 → 2 → ... → 60
F-66
is
= , =
0
0 80(Hz)
Output frequency
) is enabled.
each time you
each time you press the
.
Default setting
changes in steps of 10.0Hz: 0.0 → 10.0 →
E6581531
key.
.