Setting Frequency Via External Contact Input (Up/Down Frequency Setting - Toshiba TOSVERT VF-PS1 Instruction Manual

[Setting of jog run setting terminal (S3-CC)]
Assign control terminal S3 ([
Title
Input terminal function selection 7 (S3)
Note: During the jog run mode, there is LOW (low speed detection signal) output but no RCH (designated frequency
reach signal) output, and PID control does not work.
•When the inverter is in panel jog mode, pressing the
•When is displayed, the inverter will be placed in forward jog run mode as long as the
•When is displayed, the inverter will be placed in reverse jog run mode as long as the
•During jog run, the direction of rotation can be changed using the
motor in the forward direction, or press the
•If you press and hold down the
The figure below shows the relationship between the operation panel jog run mode and each of the other modes.
Pressing the key, which will move the inverter through each of the modes.
MODE
Note1: When the inverter is in operation (RUN key lamp is lit) or when an operation command is issued (RUN key lamp
is lit), the inverter cannot be switched to operation panel jog run mode.
Note 2: When parameter
message saying that it is in panel jog run mode.
6.11

Setting frequency via external contact input (Up/Down frequency setting)

: Input from external contacts - Up response time
: Input from external contacts - Up frequency step
: Input from external contacts - Down response time
: Input from external contacts - Down frequency step
: Initial Up/Down frequency
: Initial Up/Down frequency rewriting
• Function
These parameters are used to set the output frequency by means of a contact signal from the external
control device.
[Parameter setting]
Title
Input from external contacts - Up response time
Input from external contacts - Up frequency step
Input from external contacts - Down response time
Input from external contacts - Down frequency step
Initial Up/Down frequency
Initial Up/Down frequency rewriting
These functions are operative when parameter
parameter
: preset speed 3] in default setting) as the jog run setting terminal.
Function
key to run it in the reverse direction.
key for 20 seconds or more, the key failure alarm "
RUN
MODE
Status monitor mode
MODE
(input terminal priority selection) is set to
Function
(frequency setting mode selection 2) is set to
Adjustment range
~
key displays , while pressing the
and
Status monitor mode
MODE
Status monitor mode
Operation panel
MODE
jog run mode
, the inverter does not display any
Adjustment range
~ s
~ Hz
~ s
~ Hz
~ Hz
:Not changed
:Setting of
when power is turned off.
(frequency setting mode selection 1) is set to
.
F-19
E6581531
Example of setting
(Jog run setting terminal)
key displays
RUN key is held down.
key is held down.
RUN
keys. Press the key to run the
" will be displayed.
Default
setting
changed
or
.
6