Copy - Toshiba E-STUDIO477S Advanced Manual

2
Check the results. When finished, press
[CLOSE].
When you performed ping:
When you performed traceroute:
Note
• When the ping/traceroute command can reach a
server, the IP address is displayed for the check result
for the server. If the command cannot reach it for some
reason, the host name is displayed instead of the IP
address.
You will be returned to the NETWORK CHECK screen.

COPY

You can change the system behavior for copy jobs, such as the
maximum number of copies, auto 2-sided mode, and the sort
mode priority.
Memo
For instructions on how to display the COPY screen, see the
following page:
 P.159 "Accessing the Admin Menu"
The screen is composed of multiple pages. Press
to navigate back and forth through the pages.
COPY screen (1/2)
Item name
MAXIMUM Press the button of the desired
COPIES maximum number of copies to be
allowed from, [999], [99], and [9].
or
Description
- 187 -
Item name
AUTO 2-SIDE Press the button of the 2-sided mode
MODE copy settings (Available only when the
Automatic Duplexing Unit is installed)
that applies by default to originals
placed in the Reversing Automatic
Document Feeder.
• OFF — Press this button to set the
2-sided mode to [1->1 SIMPLEX].
• 1->2 DUPLEX — Press this button
to set the 2-sided mode to [1->2
DUPLEX].
• 2->2 DUPLEX — Press this button
to set the 2-sided mode to [2->2
DUPLEX].
• USER — Press this button to
automatically display the screen to
select the 2-sided mode when
originals are placed in the Reversing
Automatic Document Feeder.
SORT MODE Select the default sort mode for copy
PRIORITY jobs. If [STAPLE] is selected, the output
is stapled on the upper left corner by
default. To staple copies, the finisher
must be installed.
COPY screen (2/2)
Item name
AUTOMATIC This option allows you to specify
CHANGE OF whether to enable the function to
PAPER SOURCE automatically change the paper source
also when the paper source has been
manually specified for a copy job.
Selecting [ON] makes the equipment
feed the same size of paper from a
different drawer when the specified
drawer becomes empty during a copy
job.
This function is always enabled for copy
jobs performed using Automatic Paper
Selection (APS). For details of APS,
refer to the Basic Guide.
Note
• When ATTRIBUTE is set to other
than [NONE] for a drawer, the paper
placed in this drawer is out of the
scope of the Automatic Change of
Paper Source function.
For instructions on how to check and/
or change attribute for a drawer, see
the following page:
 P.146 "DRAWER"
SUSPEND This option allows you to select whether
PRINTING IF to stop printing when the stapler is
STAPLER EMPTY empty during stapling.
• ON — Press this button to stop
printing.
• OFF — Press this button to continue
printing without stapling.
SETTING ITEMS (ADMIN)
Description
Description
1
2
3
4
5
6
7