Invacare MK6i Field Reference Manual page 21

4-QUAD (4 - Quadrant)
• Allows four quadrants of the driver control to operate the mouse in four directions, (up, down, left, right).
• Typically used with Standard Joystick Operation.
• Requires a dedicated switch for Mouse Click(s) or use of "Dwell Software" if switch access is unobtainable.
3-QUAD (3 - Quadrant)
• Forward Command - Toggles between Mouse UP and Mouse Down.
• Right Command - Toggles between Mouse Left and Mouse Right.
• Left Command - Single hit for single Mouse Click, two hits for Double Click, press and hold for Mouse Latch (single hit to Unlatch/release).
• No additional switch required for Mouse Click(s), uses left driver command.
• Typically used with Head Controls where only 3 driving commands are available. Also used with chin controls, Sip-n-Puff joysticks and mini joysticks when switch
access for mouse click is unobtainable.
• 3 Quadrant always operates as above - even when proportional joysticks are set in 3-Quadrant Mode.
DIGITAL MOUSE SETTINGS
PARAMETER
Switch Delay
Drag Latch Time
Base Speed
High Speed Delay
High Speed Factor
Part No 1160891
Allows a delay from switch activation to switch recognition. The mouse will not respond until the driver control has
been active for a set time.
This parameter is enabled when the value is not zero and is typically used with 3-Quadrant controls. This allows a
sustained left command to latch an icon/graphic handle, and then use right and forward commands to re-position
the icon/handle.
This is a percentage of the mouse speed and sets the mouse speed for digital driver controls.
Used with very slow base speeds. Parameter determines the delay for the mouse speed to ramp up to a higher
speed. If the parameter is zero, the mouse speed does not ramp up.
Used with High Speed Delay to increase mouse speed movement when moving cursor across the PC desktop.
Choices are NONE, 2X, 4X and 8X.
8 Mouse Emulation Setup Programming and Usage
DESCRIPTION
21
Invacare® MK6i™IR Control/ Mouse Emulation