Using The Ir Feature - Invacare MK6i Field Reference Manual

6 Using the IR Feature

6 Using the IR Feature
6.1 Selecting the IR Mode

For this procedure, refer to FIGURE 1.
To use the IR Control Mode, power up the wheelchair normally (not in
programming mode), select the appropriate drive and select the IR
Mode. The following screen shot from the MK6i Display Unit indicates
that the IR Control Mode is in Drive 4.
FIGURE 1 Selecting the IR Mode
6.2 Selecting the Device

For this procedure, refer to FIGURE 2.
After selecting the IR Control Mode, the IR Control Screen is displayed
as depicted by the next figure. In this example, there is a TV and a Phone
Invacare® MK6i™IR Control/ Mouse Emulation
setup and the TV is highlighted. The left-most icon
to GO BACK to exit the IR Control Mode.
If IR Control is set to 4-QUAD, use the Right or Left driver commands
to scroll left and right to a different device or the GO BACK feature. Use
the Forward command to "Select the Device" which then displays the
next screen.
If IR Control is set to 3-QUAD, use the right command to scroll right to
the next device or continue scrolling to wrap around to the GO BACK
icon. Use the Left driver command to "Select the Device" (icon) which
then displays the next screen.
IR Control
Mode
14
In 3-QUAD mode, the forward command is

inactive.
FIGURE 2 Driver Commands
can be selected
Part No 1160891