Invacare MK6i Field Reference Manual page 12

5 Infrared Setup, Programming and Usage
Using the Basic SD-Card
The Basic SD-Card allows adding/programming new IR Devices and their codes, and even supports the "learning" feature. The Basic SD-card does
not allow altering the IR control (Turning on 3-Quad or 4-Quad) for individual drives.
1. Turn off the power to the wheelchair.
2. Insert the Basic SD-Card into the MK6i Display (or Joystick)
3. Turn on the wheelchair.
4. Use the down arrow (Display), or reverse command (MPJ+), to scroll down to IR SETTINGS.
5. Use the right arrow (Display), or right command (MPJ+), to select.
6. The rest of the programming is identical to that described above. Please note that enabling and disabling the IR Control Mode in a drive is only
possible with the Professional SD-Card or a hand held programmer.
IR Learning
The IR/Mouse Module has "learning" capabilities. This means that the
IR/Mouse can learn an individual button command from an existing
remote control. This is useful if, for example, you have a TV that is not
listed in the Code List or if the TV Code does not properly operate all
of the commands. In other words, if the device does not work you can
use the remote control to teach the IR/Mouse Module the infrared
sequence.
1. From the main menu of the remote hand held programmer, select
<CALIBRATIONS>.
2. Scroll down to <IR SETTINGS> and press <SELECT>.
3. Scroll down to desired device to learn the IR Signals and press
<SELECT>.
4. Enter a code of "0" and press <SELECT>. When the DEVICE
CODE is 0, learning is enabled.

For this procedure, refer to FIGURE 1.
5. Select the next menu item, <LEARN>.
Invacare® MK6i™IR Control/ Mouse Emulation
FIGURE 1 IR Learning
12
Part No 1160891