Table of Contents
Advertisement
4.2.8 BT Test Mode Specification
Initial condition of the BT MODE (BT source) will display as following.
Status
BT MODE
B
T
B
T
* "BT(HF1)" dot lights on when the BT module is started, since it takes a while to start the BT module.
"BT(HF1)" dot is blinking during startup of the BT module, and turned off when an error occurs.
Lighting display can be checked in sources except for the STANDBY source.
4.2.8.1
Operations during BT MODE
Operation
ACCENT
Clear the BT
related memory
information *1
SEARCH BT device search
VOL
Internal loop back
ON *2
Display content
M
O
D
E
E
R
R
O
R
Display content
I
N
I
T
I
A
L
I
B
T
I
N
I
T
B
T
I
N
I
T
(The display blinks)
S
E
A
R
C
H
I
N
X
X
X
X
X
X
X
X
U
N
K
N
O
W
N
I
N
T
L
O
O
P
(No.WA063<Rev.003>)20/31
BT MODE display
BT module error display
P-CON is off at the time of an error.
(Error display appears and P-CON is turned OFF when switched
to the BT source)
P-CON recovers with Power OFF/ON.
Clear the BT MODE and transition to the last source.
Press and hold this key for 2 seconds. The character
Z
E
string as shown in the left cell is displayed while the
BT related memory is being initialized.
This is to initialize the BT related memory to its fac-
:
O
K
tory default condition. When the initialization is suc-
:
N
G
cessfully completed,"...OK"(upper) is displayed, and
when the initialization is abnormally completed,
"...NG"(lower) is displayed.
Perform a BT device search for 15 seconds after
pressing the button.
G
Exit the SEARCHING standby when 1 device is
found.
Name of the found device is displayed if a device is
found during the search.
Pressing a key other than [SEARCH] after the
X
X
X
X
X
search will enter to the mode that is assigned to the
key.
If no device is found upon completion of the search;
only in this case, perform a search again by pressing
the [VOL] key.
Upon completion of the search, press the [SEARCH]
key to clear the mode.
• Press and hold this key to set the Volume to 15
and turn ON the internal loop back function.
While doing so, the internal loop back display on
the left appears after the Volume change display.
• INT LOOP R: internal loop back display of a REAR
(external) mic. Set the value of MIC GAIN to 0.
• Default value for models with the mic setting is
FRONT.
R
• For models without the mic setting, mic position of
each model is displayed.
• While in the ON state, no change in display other
than [F] or [R].
• Set the BT speaker output to ALL.
To exit the loop back, clear the mode by pressing the
[VOL] key.
Details
Details
Hide quick links:
Advertisement
Table of Contents
