Furuno FAR-3320W Installation Manual page 56

2. WIRING
2.3.2 Transceiver unit for FAR-3320W
Antenna cable, serial cable, sub monitor cable
1. Remove the cover of the unit.
2. Unfasten the bolts from the cable clamp. Lay the cables in respective cable slots
so their armors rest in the slots.
3. Connect the power line of the antenna cable, serial cable and sub monitor cable
on the RF-TB board. See the figure on the next page for pin arrangement, etc.
• Antenna cable (power): TB801
• Serial cable: TB802, TB803
• Sub monitor cable (serial): TB803
• Sub monitor cable (coaxial): TB804
2-20
TB803
TB804
TB801
TB802