• Install the processor unit on the floor, or on a bulkhead with the following direction
(horizontal), because of the DVD drive unit.
1.6.2
How to install the processor unit
Use six bolts (M6, local supply) to fasten the processor unit.
1. Use 10 binding head screws (M48, supplied) to attach the chassis bases 1 and
2 to the processor unit.
Note: For bulkhead mounting, attach the chassis base 2 so that the notches on it
are facing the deck.
Notches
2. Use six bolts (M6, local supply) to fasten the processor unit.
For bulkhead mounting, fasten three bolts for the lower bolt holes, leaving 5 mm
of thread exposed from the bolt head. Set the notches of the processor unit on the
three bolts, then fasten three bolts for the upper bolt holes. Then secure the pro-
cessor unit in place with all six bolts fastened tightly.
OK
Chassis base 1
Chassis base 2
UP
Notches
: Bolt holes (notches)
1. INSTALLATION
1-19