Table of Contents
Advertisement
Interface Modules
Label
5
6
7
8
9
Interface Modules
The network interfaces are provided through pluggable interface modules.
The following list describes the various IM port density:
• GE SFP ports—Supports 100/1000 modes
• GE Copper RJ45 ports—Supports 10/100/1000 operation
• 10GE SFP+ or XFP ports—Supports 10G mode in Phase2 IMs
• 10GE port on Phase2 IMs—Supports LAN, WAN, OTU1e/2/2e modes of operation
• 2X40 GE interface module—Supports QSFP mode
• T1/E1 ports with integrated inter-office surge protection—Supports TDM channelized, PWE3 processing
• chOC3/STM1 with ATM and CE—Supports (as low as DS0 although not for all channels simultaneously)
• chOC12/STM4 with ATM and CE—Supports (as low as DS0 although not on all channels simultaneously)
• OC3c/STM1c with ATM and CE
• OC12c/STM4c with ATM and CE
• DS3 through RAD SFPs in GE IM
• 100GE CPAK ports using 1x100G IM
• T1/E1 ports with integrated inter-office surge protection-Supports TDM channelized, PWE3 processing
• T3/E3 ports - Supports TDM channelized, PWE3 Processing
• OC3/OC12/OC48/OC192 - Supports TDM channelized, PWE3 Processing
Note
For information about supported interface modules, see the data sheet for the Cisco ASR 900 Series
Aggregation Services Routers .
Cisco ASR 907 Router Hardware Installation Guide
14
Interface
GNSS RF IN (SMA Threaded Connector)
USB console port
USB memory port
Ethernet management port
BITS timing port
and ATM IMA bundles
Cisco ASR 907 Router Overview
Advertisement
Table of Contents
