Interface Modules - Cisco NCS 4216 Manual

Cisco NCS 4216 Overview
Label
5
6
7
8
9

Interface Modules

The network interfaces are provided through pluggable interface modules.
The following list describes the various IM port density:
• GE SFP ports—Supports 100/1000 modes
• GE C-SFP ports—Supports 100/1000BASE-BX modes
• 100GE CPAK ports using 1x100G IM
• 10GE ports through SFP+
• 2X40 GE interface module—Supports QSFP mode
• T1/E1 ports with integrated inter-office surge protection—Supports TDM channelized, PWE3 processing
• T3/E3 ports - Supports TDM channelized, PWE3 Processing
• OC3/OC12/OC48/OC192 - Supports TDM channelized, PWE3 Processing
Note For information about supported interface modules, see the data sheet for the
Aggregation Services
The Cisco NCS 4216 interface modules are a field-replaceable units. In addition to the ports provided on an
RSP, the Cisco NCS 4216 supports the interface modules.
Routers.
Interface
GNSS RF IN (SMA Threaded Connector)
USB console port
USB memory port
Ethernet management port
BITS timing port
Cisco NCS 4200 Series
Cisco NCS 4216 Hardware Installation Guide
Interface Modules
13