Table of Contents
Advertisement
Standard Warning Statements
Ultimate disposal of this product should be handled according to all national laws and regulations. Statement
Warning
1040
To prevent the system from overheating, do not operate it in an area that exceeds the maximum
Warning
recommended ambient temperature of 149°F (65°C). Statement 1047
The chassis should be mounted on a rack that is permanently affixed to the building. Statement 1049
Warning
Warning
Invisible laser radiation may be emitted from disconnected fibers or connectors. Do not stare into beams
or view directly with optical instruments. Statement 1051
Warning
Class 1M laser radiation when open. Do not view directly with optical instruments. Statement 1053
Class I (CDRH) and Class 1M (IEC) laser products. Statement 1055
Warning
IMPORTANT SAFETY INSTRUCTIONS: This warning symbol means danger. You are in a situation
Warning
that could cause bodily injury. Before you work on any equipment, be aware of the hazards involved with
electrical circuitry and be familiar with standard practices for preventing accidents. Use the statement
number provided at the end of each warning to locate its translation in the translated safety warnings that
accompanied this device. Statement 1071
This is a Class A Device and is registered for EMC requirements for industrial use. The seller or buyer
Warning
should be aware of this. If this type was sold or purchased by mistake, it should be replaced with a
residential-use type. Statement 294
Warning
This is a class A product. In a domestic environment this product may cause radio interference in which
case the user may be required to take adequate measures. Statement 340
Warning
This equipment is in compliance with the essential requirements and other relevant provisions of Directive
1999/5/EC.
Cisco ASR 907 Router Hardware Installation Guide
18
Preparing for Installation
Advertisement
Table of Contents
