Installing The Cable Connectors; T1/E1 Cable Connectors; 16 X T1/E1 Cable Connectors - Cisco ASR 907 Hardware Installation Manual

Hide thumbs Also See for ASR 907:
Table of Contents

Advertisement

Installing the Cisco ASR 907 Router
Patch panels are required in order to connect the high-density interface connectors to individual T1/E1
Note
lines.

Installing the Cable Connectors

T1/E1 Cable Connectors

One end of the cable has a 68-pin connector that plugs into the T1/E1 interface module. Use the thumbscrews
on either side of the connector to secure the cable to the interface. The other end of the cable has two 68-pin
connectors that attach to the rear of a 48-port RJ48 or DIN patch panel.
Figure 45: T1/E1 Cable Connector

16 x T1/E1 Cable Connectors

Figure 46: 16 x T1/E1 Cable Connector
Connecting T1/E1 Cables
Cisco ASR 907 Router Hardware Installation Guide
105

Advertisement

Table of Contents
loading

Table of Contents