Tool Offset Number D (Turning) - Siemens sinumerik 808d Programming And Operating Manual

Programming
T...
Programming example
Tool change without M6
N10 T1
N20 T3
N30 T2
N40 T6
N50 T7
N60 T5
N70 T588
N80 M30
A maximum of 64 tools can be stored in the control system.
1.6.3

Tool offset number D (turning)

Functionality
It is possible to assign 1 to 9 data fields with different tool offset blocks (for multiple cutting
edges) to a specific tool. If a special cutting edge is required, then it can be programmed
using D and the appropriate number.
If a D word is not written, D1 is automatically effective.
If D0 is programmed, the offsets for the tool are ineffective.
Programming
D...
A maximum of 64 data fields (D numbers) for tool offset blocks can be stored simultaneously
in the control system:
Information
Tool length compensations become effective immediately when the tool is active; when no D
number was programmed with the values of D1.
Turning Part 2: Programming (Siemens instructions)
Programming and Operating Manual, 05/2012, 6FC5398-5DP10-0BA0
; Tool number: 1 ... 32 000
; Tool offset number: 1 ... 9, D0: No offsets active!
Programming principles
1.6 Tool and tool offset
73