Siemens sinumerik 808d Programming And Operating Manual page 110

Cycles
2.4 Drilling cycles
Figure 2-2
Dwell time programming
The parameters for dwell times in the drilling cycles are always assigned to the F word and
must therefore be assigned with values in seconds. Any deviations from this procedure must
be expressly stated.
Special features when using drilling cycles on a turning machine
Simple turning machines without driven tools can apply drilling cycles only for drilling on the
end face (with Z-axis) in the turning center. These drilling cycles must always be called in the
G17 plane.
Figure 2-3
110
Drilling axis when turning
Drilling on turning center without a driven tool
Turning Part 2: Programming (Siemens instructions)
Programming and Operating Manual, 05/2012, 6FC5398-5DP10-0BA0