Siemens sinumerik 808d Programming And Operating Manual page 155

Programming example 1: Plunge-cutting
This program is used to produce a groove externally at an oblique line in the longitudinal
direction.
The starting point is on the right-hand side at X35 Z60.
The cycle will use the tool compensations D1 and D2 of tool T5. The cutting tool must be
defined accordingly.
N10 G0 G90 Z65 X50 T5 D1 S400 M3
N20 G95 F0.2
N30 CYCLE93(35, 60, 30, 25, 5, 10, 20, 0, 0, -2,
-2, 1, 1, 10, 1, 5,0.2)
N40 G0 G90 X50 Z65
N50 M02
Turning Part 2: Programming (Siemens instructions)
Programming and Operating Manual, 05/2012, 6FC5398-5DP10-0BA0
2.5 Turning cycles
;Starting point before the
beginning of the cycle
; Specification of technology
values
; Cycle call
Retraction distance of 0.2 mm
programmed
;Next position
; End of program
Cycles
155