Circular Interpolation Via Intermediate Point: Cip - Siemens sinumerik 808d Programming And Operating Manual

Programming example: Definition of center point and aperture angle
Figure 1-14
N5 G90 Z30 X40
N10 G2 K10 I-7 AR=105
Note
Center point values refer to the circle starting point!
1.3.5

Circular interpolation via intermediate point: CIP

Functionality
The direction of the circle results here from the position of the intermediate point (between
starting and end points). Specification of intermediate point: I1=... for the X axis, K1=... for
the Z axis.
CIP remains active until canceled by another instruction from this G group (G0, G1, ...).
The configured dimensional data G90 or G91 applies to the end point and the intermediate
point.
Figure 1-15
Turning Part 2: Programming (Siemens instructions)
Programming and Operating Manual, 05/2012, 6FC5398-5DP10-0BA0
Example for center point and aperture angle
; Starting point circle for N10
; Opening angle and center point
Circle with end point and intermediate point specification using the example of G90
Programming principles
1.3 Axis movements
41