Siemens sinumerik 808d Programming And Operating Manual page 174

Cycles
2.5 Turning cycles
"New file"
"Attach
contour"
"OK"
174
3. The "Name of contour subroutine" screen for CYCLE 95 opens.
Parameterise the cycle according to the requirement.
4. The contour can be edited and stored in a Subroutine using the "New
file" softkey.
The contour can be edited and stored in the main program file after the
M30 command when using the "Attach contour" softkey.
5. Press "OK". The values and cycle call are transferred into the part
program as shown below:
Programming and Operating Manual, 05/2012, 6FC5398-5DP10-0BA0
Turning Part 2: Programming (Siemens instructions)