Workpiece Clamping - Settable Work Offset: G54 To G59, G500, G53, G153 - Siemens sinumerik 808d Programming And Operating Manual

Programming principles
1.2 Positional data
Information
In addition to the programmable offset and the scale factor, the following functions exist:
● Programmable rotation ROT, AROT and
● programmable mirroring, MIRROR, AMIRROR.
These functions are primarily used in milling.
Examples of rotation and mirroring: see the topic "List of instructions (Page 12)".
1.2.7

Workpiece clamping - settable work offset: G54 to G59, G500, G53, G153

Functionality
The adjustable work offset specifies the position of the workpiece zero on the machine
(offset of the workpiece zero with respect to the machine zero point). This offset is
determined upon clamping of the workpiece into the machine and must be entered in the
corresponding data field by the operator. The value is activated by the program by selection
from six possible groupings: G54 to G59.
Programming
G54 to G59
G500
G53
G153
Figure 1-6
Programming example
N10 G54 G0 X50 Z135
N20 X70 Z160
N30 T1 D1
N40 M3 S1000
34
; 1. to 6th settable work offset
; Settable work offset OFF - modal
; settable work offset OFF non-modal, also suppresses programmable
offset
; As with G53; additionally suppresses base frame
settable work offset
Turning Part 2: Programming (Siemens instructions)
Programming and Operating Manual, 05/2012, 6FC5398-5DP10-0BA0