Siemens sinumerik 808d Programming And Operating Manual page 167

Value
10
11
12
In longitudinal machining, the infeed is always carried out along the transversal axis, and in
face machining - along the longitudinal axis.
External machining means that the infeed is carried out in the direction of the negative axis.
With internal machining, the infeed is carried out in the direction of the positive axis.
The VARI parameter is subjected to a plausibility check. If its value is not in the range 1 ... 12
when the cycle is called, the cycle is aborted with alarm 61002 "Machining type defined
incorrectly".
Turning Part 2: Programming (Siemens instructions)
Programming and Operating Manual, 05/2012, 6FC5398-5DP10-0BA0
Longitudinal/fac Ext./int.
e
P O
L I
P I
Roughing/finishing/complete
Complete machining
Complete machining
Complete machining
Cycles
2.5 Turning cycles
167