Siemens sinumerik 808d Programming And Operating Manual page 173

N110 G18 DIAMOF G90 G96 F0.8
N120 S500 M3
N130 T1 D1
N140 G0 X70
N150 Z160
N160 CYCLE95("START:END",2.5,0.8,
0.8,0,0.8,0.75,0.6,1, , , )
N170 G0 X70 Z160
N175 M02
START:
N180 G1 X10 Z100 F0.6
N190 Z90
N200 Z70 ANG=150
N210 Z50 ANG=135
N220 Z50 X50
END:
N230 M02
Programming example3
The easiest way to rough and finish around a contour is to use the contour turning cycle.
"Turn."
"Stock removal" 2.
Turning Part 2: Programming (Siemens instructions)
Programming and Operating Manual, 05/2012, 6FC5398-5DP10-0BA0
1. From the program editor screen, press "Turn.".
From the vertical softkey, select "Stock removal" and parameterise the
cycle according to the requirement.
2.5 Turning cycles
; Cycle call
Cycles
173