Panasonic WJ-NX400K Operating Instructions Manual page 36

[Setup via recorder's main monitor]
Ext.: Alarm output will continue until the alarm
action is reset.
Default: 30 s
[Pre-event duration]
Set the recording duration before an alarm occurs.
0 s/ 5 s/ 10 s/ 15 s
Default: 0 s
Important:
• The pre-event recording is only available for Camera
1 to Camera 32.
• The pre-event recording available time becomes
extremely short when the sub-stream recording is on.
• The pre-event recording is available for Camera 1 to
Camera 64 at the additional camera (96ch/128ch)
mode.
Note:
• The actual recording time may sometimes be
longer than the duration selected for this setting.
• A 15 second pre-event recording is available when
the bit rate setting of the camera is 3 Mbps (1 Mbps
during the sub-stream recording). Time of the pre-
event recording may be shorter than the set time if
the image is recorded in high resolution over 3 Mbps
(1 Mbps), high image quality and high rate.
• Pre-event recording is not performed when "0 s"
is selected.
• When images are set to be recorded together with
audio, the audio may not be recorded at the
beginning of the pre-event recording.
■ Schedule to record
Two time tables can be set.
[Schedule recording] (☞ Page 34)
[Event recording] (☞ Page 34)
[e-Mail] (☞ Page 34)
[Panasonic alarm protocol] (☞ Page 34)
[Prev page] / [Next page]
The schedule settings to be configured will be
switched over.
[Display the schedule list.]
Displays each time table from Schedule 1 to Sched-
ule 16 and settings of the schedule recording and
event recording. The schedule list will be displayed
when clicking [View] button.
Time zones from 1 to 6 of each time table are super-
imposed and displayed.
[Back] button
Click the button after completing the settings. The
screen returns to the [Recording setup] tab.
36