Drying The Trailing Edge Of The Printing Area On The Dryer - Roland soljet pro4 xf 640 User Manual

Fully Utilize the Media Heating System

PREHEATING
30°C
MENU
30°C
OFF

Press
Default Setting
[PREHEATING]: 30°C

Drying the Trailing Edge of the Printing Area on the Dryer

4
Procedure

Hold down

HEATER MENU
FEED FOR DRY

FEED FOR DRY
DISABLE

Press
Description
 "ENABLE" : media feed is performed until the trailing edge of the printing area is positioned on the dryer. The
margin between the print-end position and the next print-start position is set to a value of 125 millimeters.
When you set the margin bigger than the value above on the software RIP, the software's setting is used.
 P. 99, "Using an Optional Dryer"
 "DISABLE" : media feed stops simultaneously when printing ends. This means that the trailing edge of the
printing area is not fed to the dryer unless you continue with a subsequent printing operation.
Default Setting
[FEED FOR DRY]: DISABLE
98
Press
MENU
Press
The system performs heating to the preset temperature at all times, without lower-
ing the temperature during preheating.
The system keeps 30°C during preheating.
The system switches the media heating system off during preheating.
in this order to go back to the original screen.
and press
Press
Press
Press
ENABLE
Press
in this order to go back to the original screen.
to select setting.
to enable the setting.
.
to display the left figure.
.
to select "ENABLE."
to enable the setting.