Table of Contents
Advertisement
•
3/16" Allen wrench (included)
•
7/32" Allen wrench (included)
•
9/16" Open end wrench (2)
•
Block, 4" (10 cm)
Lift and move unit
1.
Remove lag bolts and shipping supports. Keep package material on linkage arms at this time. This will protect the paint
from scratching during assembly.
2.
Grasp each rear support leg firmly and lift with one person on each side.
3.
Lift the lower rear support legs so the front transport wheels are able to roll on floor.
Use proper lifting methods.
4.
Move unit to intended location.
5.
Lower rear support legs.
Install grommets in console weldment
Insert two small grommets into console weldment.
Install cables to console
Plug the console cables into the console.
NOTE: The ground wire is connected to the console weldment.
1
2
Page 18 of 29
Description
Console weldment
Grommet, small
Qty.
1
2
Advertisement
Table of Contents
