Table of Contents
Advertisement
6.
Press back cover assembly into spring tab holes of console weldment.
7.
Install back cover assembly with two screws using a Phillips screwdriver.
Install console assembly
1.
Place console assembly into position on frame.
NOTE: Do not pinch cables while lowering console assembly.
2.
Insert (from underneath) four bolts and lower bracket into frame and console assembly.
3.
Thread four locknuts onto bolts by hand.
4.
Tighten four bolts and locknuts with a 7/32" Allen wrench and a 9/16" open-end wrench.
1
2
3
4
1
2
3
4
5
Page 20 of 29
Description
Console
Spring tab holes
Back cover assembly
Screw, M4.2 x 0.7 x 19
Description
Console assembly
Frame
Lower bracket
Bolt, 0.375-16 x 2.5"
Locknut, 0.375-16
Qty
1
1
1
2
Qty
1
1
1
4
4
Advertisement
Table of Contents
