Initial Setting; Overview; Entering The Mode For Initial Setting - Pentax R-315EX(NX) Instruction Manual

8. INITIAL SETTING

8.1 Overview

For the R-300X series, you can select and save the desired setting for a variety of
prescribed instrument conditions, called Initial Setting.
The Initial Setting is saved in five modes,"Initial Setting 1" , "Initial Setting 2" ,
"Initial Setting 4" , "Initial Setting 5" , and "Setting of Date and Time " in which you can select
and save the instrument conditions described below.
The factory default for each of these conditions is marked by
To change Initial Setting, follow the operating procedures for entering each Initial Setting
mode on "8.2" and the operating procedures for changing an Initial Setting on "8.2" .
• There is no Date and Time setting with the models R-315EX, R-325EX, R-326EX
and R-335EX.

8.2 Entering the mode for initial setting 1

Press the [POWER] key while holding [F1] key
down to access the screen for Initial Setting 1.
Press [F3] [ ] or [F4] [ ] to position
the cursor at the item of interest.
8.3 Entering the mode for initial setting 2
Press the [POWER] key while holding [F2] key
down to access the screen for Initial setting 2.
• Select the item of interest in the same way as in the mode for Initial setting 1.
• Pressing [F2] [
five items.
48
] scrolls the screen down five items; pressing [F1] [
.
SET 1
1. ATM CORR : AUTO
2. PRISM CONST : 0mm
3. SHEET CONST : 0mm
4. CRV/REF CORR : 0.14
5. COMP AXIS : NIL
SET 1
1. ATM CORR : AUTO
2. PRISM CONST : 0mm
3. SHEET CONST : 0mm
4. CRV/REF CORR : 0.14
5. COMP AXIS : NIL
SET 2
1. MEAS MIN DISP : COARSE
2. SHOT COUNT : 1 TIME
3. SHEET INPUT : 01 TIMES
4. LD PLUM : ON
5. TILT DISP : ON
] scrolls it up
SELECT
SELECT
SELECT