Panasonic WV-V2530LK Operating Instructions Manual page 40

Parameter Function
Profile You may select Normal, Day and Night mode.
Brightness It is to adjust monitor window bright. You can adjust this value
if the video is too dark or too bright. The larger the number, the
bright the video is. When you input the value here, the bright
section and the dark section of the video will be adjusted
accordingly. Please note the video may become hazy if the
value is too high.
The value ranges from 0 to 100. The recommended value
ranges from 40 to 60. The default value is 50.
Contrast It is to adjust monitor window contrast. The larger the number,
the higher the contrast is. You can use this function when the
whole video bright is OK but the contrast is not proper. Please
note the video may become hazy if the value is too low. If this
value is too high, the dark section may lack brightness while
the bright section may over exposure.
The value ranges from 0 to 100. The recommended value
ranges from 40 to 60. The default value is 50.
Saturation It is to adjust monitor window saturation. The larger the
number, the strong the color is. This value has no effect on the
general brightness of the whole video. The video color may
become too strong if the value is too high. For the grey part of
the video, the distortion may occur if the white balance is not
accurate. Please note the video may not be attractive if the
value is too low.
The value ranges from 0 to 100. The recommended value
ranges from 40 to 60. The default value is 50.
Sharpness The value here is to adjust the edge of the video. The larger
the value is, the clear the edge is and vice versa. Please note
there is noise if the value here is too high.
The value ranges from 0 to 100. The recommended value
ranges from 40 to 60. The default value is 50.
Gamma The value here is to adjust the gamma value of the video.
The value ranges from 0 to 100. The recommended value
ranges from 40 to 60. The default value is 50.
Mirror It is to switch video left and right limit.
This function is disabled by default.
The function can be used to change the direction of video
Image rotation
surveillance image. It can select 0,90,180,270 degree.
36