Image Adjust - Panasonic WV-V2530LK Operating Instructions Manual

Parameter
Audio enable
Encode mode
Sampling
frequency
Audio in type
Noise filter
Microphone
volume
Speaker volume

Image adjust

6.2.2
Here you can view device property information. Slight differences may be found due to different network
camera series. The setups become valid immediately after you set..
6.2.2.1 Picture
Function
Check Enable: the stream is A/V composite stream,

otherwise it contains video only.
Note:
Audio can be enabled only when video is enabled.
The encode mode includes G.711Mu, G.726 and AAC.
Note:
The audio encode mode set here can make both audio stream
and bidirectional talk valid at the same time.
Only AAC is supported for recording audio to SD card.
It includes 8k,16k, 32k and 48k. It is 8k by default.
It can be selected only 8k when selecting G.726 and G.711Mu.
It is to set audio input type, it is LineIn by default.
It is to set if it is to enable noise filter function, it is disable by
default.
It is to adjust the volume of the microphone; the value range is
from 0 to 100.
It is to adjust the volume of the speaker; the value range is from
0 to 100.
Figure 6-11
35