Panasonic UF-6300 Service Manual page 208

No. Parameter
34 ENERGY SAVER
MODE
35 DAYLIGHT TIME
36 RING PATTERN
(DRD)
37 RCV TO
MEMORY
38 ACCESS CODE
39 PIN CODE
ACCESS
42 CONF. FILE
SAVE
43 PASSWORD-
XMT
44 PASSWORD-
RCV
46 SELECT RCV
47 REMOTE RCV
48 TELEPHONE
LINE
49 PSTN ACCESS
CODE
Setting
Setting
Number
1 OFF
2 ENERGY-
SAVER
3 SLEEP
1 OFF
2 MAR 2nd
3 APR 1st
1 INVALID
2 VALID
(----)
(----)
1 NONE
2 SUFFIX
3 PREFIX
1 INVALID
2 VALID
1 OFF
2 ON
1 OFF
2 ON
1 INVALID
2 VALID
1 INVALID
2 VALID
1 PSTN
2 PBX
(----)
To reduce the power consumption in standby, select
either Energy-Saver or Sleep mode and specify the
Delay Time (1 to 120 minutes) for the machine to enter
into the selected mode.
The Delay Timer setting is only available in the Energy-
Saver or Sleep Modes.
OFF : The unit will remain in standby mode
and consume more energy than when
in Energy-Saver or Sleep modes.
ENERGY-SAVER: Saves energy by consuming less
power than when in standby mode by
turning off the fuser unit after the
specified time.
SLEEP : This is the lowest power state that the
machine enters after the specified
time without actually turning off.
Set the Daylight Time according to your local regulation.
OFF : Daylight time is not applied.
MAR 2nd : From 2:00 AM on the 2nd Sunday in March to
2:00 AM on the 1st Sunday in November.
APR 1st : From 2:00 AM on the 1st Sunday in April to
2:00 AM on the Last Sunday in October.
Selecting whether or not the machine is available for
"DRD Service". If this parameter is set to "VALID", your
machine detects the specified ring pattern only when
receiving a document automatically.
Enter a 4-digit password used to print out the received
document in memory by using F8-5 (RCV TO MEMORY).
When F8-5 is set to ON, this parameter will not be shown
on the LCD display.
Enter a 4-digit Access Code to secure the machine
fromunauthorized use.
Selecting the access method (Prefix or Suffix) to dial a
number with PIN Code.
Selecting whether the machine saves the confidential
polled file even after the file is polled once.
Setting a 4-digit XMT-Password and selecting whether
the machine performs and checks the XMT-Password of
the receiving station when transmitting.
Setting a 4-digit RCV-Password and selecting whether
the machine performs and checks the RCV-Password of
the transmitting station when receiving.
Selecting whether the machine performs
selectivereception.
Selecting whether or not the machine accepts remote
reception command.
Selecting the type of line connected.
Setting PSTN Access Code. (Up to 4 digits)
208
Comments