Panasonic UF-6300 Service Manual page 121

Code Mode Phase
438 RCV
456 RCV
459 RCV
490 RCV
494 RCV
495 XMT
RCV
496 XMT
501 XMT/
RCV(V.34)
502 XMT/ B, C, D During reception, CD turned OFF
RCV(V.34)
503 XMT/ B, C, D CS of modem is not able to turn ON
RCV(V.34)
504 XMT/V.34
(Polling)
505 XMT/V.34
(Polling)
540 XMT ECM
541 XMT ECM
542 XMT ECM
543 XMT ECM
544 XMT ECM
550 RCV ECM
554 RCV ECM
555 RCV ECM
Fax Information Codes
Description of Problem
B Refusal ID (Junk Fax ID) received
in Phase B.
B Received relay transfer request or
confidential document to distribute
to an end receiving station or all
confidential mailboxes are used.
C Failed training in Phase C.
C Sum of error lines exceeded the
limit (Function Parameter No. 70) of
64 lines.
C Interval between two EOLs was
more than 10 sec. when receiver
received message data.
C During reception, CD turned OFF
or continued ON for long time.
During communication, lost loop -
current.
C CS of modem is not able to turn
ON.
B Remote unit does not have
compatible Modem.
or continued ON for long time.
During communication, lost loop -
current.
during training.
B Polling is rejected from the remote
station.
B Polling XMT is rejected.
B No response after transmitting 3rd
CTC or DCN received.
D No response after transmitting 3rd
EOR or received DCN.
D No response to the 3rd RR
transmitted or received DCN.
D T5 timer (60 sec.) elapsed without
MCF.
D Stopped Transmission after EOR
Transmission.
C Timer between frames in phase C
has elapsed.
D Transmitted ERR after receiving
EOR.
D Transmitted PIN after receiving
EOR.
Transmitter ID is registered as a Junk
Fax. JUNK is printed as the Information
Code on the Comm. Journal.
Line quality is poor. (Training signal is
distorted due to line noise)
SC PCB or MJR PCB are defective.
Line quality is poor.
SC PCB or MJR PCB are defective.
Transmitter is defective.
Line quality is poor. (EOL is damaged
due to line noise)
SC PCB or MJR PCB are defective.
Line is disconnected.
Transmitter is defective.
SC PCB or MJR PCB are defective.
SC PCB is defective.
Line is disconnected.
Transmitter is defective.
SC PCB or MJR PCB are defective.
SC PCB is defective.
Line is disconnected.
No polling original is set.
No polling original is set.
Incompatible interface.
Line is faulty.
MJR PCB abnormal.
Remote unit is abnormal.
Remote unit is abnormal.
Line is faulty.
MJR PCB abnormal.
Defective remote station.
Line is faulty.
Line is faulty and Operator Call
requested by RX side.
121
Cause