Command Details - Omron FQ2-S/CH Series User Manual

Command Details

Details for PLC Link, EtherNet/IP(Tag Data Link) and PROFINET commands
Single Measurement
This command executes one measurement.
Command (PLC to Sensor)
First word of com-
mand area
+2
+3
Response (Sensor to PLC)
First word of
response area
+2
+3
+4
+5
Note
The measurement results are written to the output area if data output is set.
The measurement results are not output if data output is not set.
Setting the Data To Output Automatically after Measurements: p. 97, 127, 153
214
Command Control
Bits
12 to 15 8 to 11 4 to 7
0001 0000 0001
0000 0000 0001
Bits
12 to 15 8 to 11 4 to 7
0001 0000 0001
0000 0000 0001
0000 0000 0000
0000 0000 0000
Contents
0 to 3
0000
Command code: 4-byte binary data
0000
Contents
0 to 3
0000 Command code
The command code for which the response
0000
applies is stored.
0000 Response code
Command execution result
0000
0: OK, FFFFFFFF: NG
FQ2-S/CH User's Manual
for Communications Settings