Selecting A Location In The Rack - HP storageworks 2/32 Installation Manual

■
■
■
■
■
Note:
application is included with the Windows 2000 operating system provided with the
HAFM server.

Selecting a Location in the Rack

Determine where to position the HP StorageWorks edge switch in the rack. These
procedures describe installation in the lowest position of the rack. For other
positions, make adjustments as required. Please note:
■
■
Edge Switch 2/32 Installation Guide
Fiber-optic protective plug—For safety and port transceiver protection,
fiber-optic protective plugs must be inserted in all switch ports without
fiber-optic cables attached.
Null modem cable—An asynchronous RS-232 null modem cable is required
to configure switch network addresses and obtain event log information
through the maintenance port. The cable has nine conductors and two DB-9
female connectors. A null modem cable specially designed for this application
is supplied with the Edge Switch 2/32.
Standard flat-tip and cross-tip Phillips screwdrivers—Required to remove,
replace, adjust or tighten various FRUs, chassis, or rack components.
Electrostatic discharge (ESD) grounding cable with attached wrist
strap—Required when working in and around the switch card cage.
Maintenance terminal (desktop or notebook computer)—Required to
configure switch network addresses and acquire event log information
through the maintenance port. Computer requirements include:
— Microsoft Windows 98, Windows Millennium Edition, Windows NT 4.0,
Windows 2000, or Windows XP operating system installed
— RS-232 serial communication software (for example, ProComm Plus, or
HyperTerminal).
The HAFM server may be used for this function. The HyperTerminal
Edge Switch 2/32 is 2.55 inches (or 1.5U) high.
If installing two 1.5U switches in the bottom of the rack, identify the screw
holes for proper alignment.
Installing and Configuring the Edge Switch 2/32
35