HP storageworks 2/32 Installation Manual page 74

Installing and Configuring the Edge Switch 2/32
7. Enter the amount of cumulative minutes in which the % utilization should
8. Enter the interval in minutes in which throughput is measured and threshold
9. Click Next. A new screen displays for selecting ports for the alerts, as shown
Figure 27: New Threshold Alerts dialog box
10. Choose either Port Type or Port List.
74
exist during the notification interval before an alert is generated. You can also
choose At any time if you want an alert to occur whenever the set %
utilization is reached. The valid range is from 1 to the interval value set in
step 8.
notifications can occur. The valid range is 5 minutes to 70,560 minutes.
in Figure 27.
■ For Port Type, choose either E_Ports or F_Ports to cause this alert to
generate for all ports configured as E_Ports or F_Ports respectively.
■ For Port List, you can choose individual ports by clicking the check box
by each port number or set all ports. Selecting Set All Ports places a
check mark by each port number. Selecting Clear All Ports clears the
check marks by each port number.
third screen
—
Edge Switch 2/32 Installation Guide