Configure Snmp Trap Message Recipients - HP storageworks 2/32 Installation Manual

Using the Embedded Web Server

Configure SNMP Trap Message Recipients

Perform this procedure to configure community names, write authorizations, and
network addresses for up to 6 SNMP trap message recipients. A trap recipient is a
management workstation that receives notification (through SNMP) if a switch
event occurs.
To configure SNMP trap recipients:
1. Choose Configure at the left side of the window. The Configure window
2. At the Configure window, click the Management tab. The Management
Figure 43: Management page—SNMP tab
100
opens with the Ports tab displayed.
page displays with SNMP tab selected
a. For each trap recipient to be configured, type a community name of 32
alphanumeric characters or less in the associated Community Name
field. The community name is incorporated in SNMP trap messages to
ensure against unauthorized viewing or use.
b. Click the check box in the Write Authorization column to enable or
disable write authorization for the trap recipient (default is disabled). A
check mark in the box indicates write authorization is enabled. When the
feature is enabled, a management workstation user can change
sysContact, sysName, and sysLocation SNMP variables.
(Figure 43).
Edge Switch 2/32 Installation Guide