HP storageworks 2/32 Installation Manual page 64

Installing and Configuring the Edge Switch 2/32
2. Use the vertical scroll bar as necessary to display additional port information
3. Click Activate to save the configuration information and close the dialog box.
64
f. Click the Speed field for a port. A Speed drop-down list displays. Choose
1 Gb/sec, 2 Gb/sec, or Navigate as the desired setting depending on the
speed capability of the device to be plugged into the port.
A right-click in the Speed column allows you to choose from a menu to
set all ports to 1 Gb/sec, 2 Gb/sec, or Navigate.
g. Click the Port Binding check box to display a check mark and enable
WWN binding for the port. This allows only a specific device to attach to
the port. This device is specified by the WWN or nickname entered into
the Bound WWN column. With the check box cleared, any device can
attach to the port even if a WWN or nickname is specified in the Bound
WWN column.
or
Enter a world wide name (WWN) in the Bound WWN field in the proper
format (xx.xx.xx.xx.xx.xx.xx.xx) or a nickname configured through the
Product Manager application. The device with this WWN or nickname
will have exclusive attachment to the port if Port Binding is enabled. If a
valid WWN or nickname is not entered in this field, but the Port Binding
check box is checked (enabled), then no devices can connect to the port. If
you enter a WWN or nickname in this field and do not place a check in
the Port Binding check box, the WWN or nickname will be stored, and
all devices can connect to the port.
rows (up to 32 ports).
Edge Switch 2/32 Installation Guide