Static Ipv6Sg Configuration Example; Dynamic Ipv6Sg Using Dhcpv6 Snooping Configuration Example - HP MSR Series Configuration Manual

[Router-GigabitEthernet2/0/1] quit
2. Enable IPv4SG on interface GigabitEthernet 2/0/1 and verify the source IP address and MAC
address for dynamic IPSG.
[Router] interface gigabitethernet 2/0/1
[Router-GigabitEthernet2/0/1] ip verify source ip-address mac-address
[Router-GigabitEthernet2/0/1] quit
Verifying the configuration
# Verify that a dynamic IPv4SG binding is generated based on a DHCP relay entry.
[Router] display ip source binding dhcp-relay
Total entries found: 1
IP Address
192.168.0.1

Static IPv6SG configuration example

Network requirements
As shown in
allow only IPv6 packets from the host to pass.
Figure 160 Network diagram
Configuration procedure
# Enable IPv6SG on GigabitEthernet 2/0/1.
<Device> system-view
[Device] interface gigabitethernet 2/0/1
[Device-GigabitEthernet2/0/1] ipv6 verify source ip-address mac-address
# On GigabitEthernet 2/0/1, configure a static IPv6SG binding for the host.
[Device-GigabitEthernet2/0/1] ipv6 source binding ip-address 2001::1 mac-address
0001-0202-0202
[Device-GigabitEthernet2/0/1] quit
Verifying the configuration
# Verify that the static IPv6SG binding is configured successfully on the device.
[Device] display ipv6 source binding static
Total entries found: 1
IPv6 Address
2001::1
Dynamic IPv6SG using DHCPv6 snooping configuration
example
Network requirements
As shown in
MAC Address
0001-0203-0406 GE2/0/1
Figure 160, configure a static IPv6SG binding on GigabitEthernet 2/0/1 of the device to
MAC Address
0001-0202-0202 GE2/0/1
Figure 161:
Interface
Interface
522
VLAN Type
N/A DHCP relay
VLAN Type
N/A Static