HP MSR Series Configuration Manual page 222

HMIM-8GSW.
HMIM-24GSW.
HMIM-24GSWP.
SIC-4GSW.
SIC-4GSWP.
•
Fixed Layer 2 Ethernet ports on the following routers:
MSR954(JH296A/JH297A/JH299A).
MSR1002-4/1003-8S.
MSR2004-24/2004-48.
Before you set a port security mode for a port, complete the following tasks:
•
Disable 802.1X and MAC authentication.
•
Verify that the port does not belong to any aggregation group or service loopback group.
•
If you are configuring the autoLearn mode, set port security's limit on the number of secure
MAC addresses. You cannot change the setting when the port is operating in autoLearn mode.
When you set the port security mode, follow these guidelines:
•
You can specify a port security mode when port security is disabled, but your configuration
cannot take effect.
•
Changing the port security mode of a port logs off the online users of the port.
•
Do not enable 802.1X authentication or MAC authentication on a port where port security is
configured.
To set the port security mode:
Step
1. Enter system view.
2. (Optional.) Set an OUI value
for user authentication.
3. Enter interface view.
4. Set the port security mode.
Command
system-view
port-security oui index
index-value mac-address
oui-value
interface interface-type
interface-number
port-security port-mode
{ autolearn | mac-authentication
| mac-else-userlogin-secure |
mac-else-userlogin-secure-ext |
secure | userlogin |
userlogin-secure |
userlogin-secure-ext |
userlogin-secure-or-mac |
userlogin-secure-or-mac-ext |
userlogin-withoui }
207
Remarks
N/A
By default, no OUI value is
configured for user authentication.
This command is required for the
userlogin-withoui mode.
You can set multiple OUIs, but
when the port security mode is
userlogin-withoui, the port
allows one 802.1X user and only
one user that matches one of the
specified OUIs.
N/A
By default, a port operates in
noRestrictions mode.
After enabling port security, you
can change the port security
mode of a port only when the port
is operating in noRestrictions (the
default) mode. To change the port
security mode for a port in any
other mode, first use the undo
port-security port-mode
command to restore the default
port security mode.