Configuring A Static Ipv4Sg Binding; Configuring The Ipv6Sg Feature; Enabling Ipv6Sg On An Interface; Configuring A Static Ipv6Sg Binding - HP MSR Series Configuration Manual

Configuring a static IPv4SG binding

Step
1. Enter system view.
2. Enter interface view.
3. Configure a static
IPv4SG binding.

Configuring the IPv6SG feature

You cannot configure the IPv6SG feature on a service loopback interface. If IPv6SG is enabled on an
interface, you cannot assign the interface to a service loopback group.

Enabling IPv6SG on an interface

When you enable IPv6SG on an interface, the static and dynamic IPv6SG are both enabled.
•
Static IPv6SG uses static bindings configured by using the ipv6 source binding command.
•
Dynamic IPv6SG generates dynamic bindings from related source modules. IPv6SG uses the
bindings to filter incoming IPv6 packets based on the matching criteria specified in the ipv6
verify source command.
To implement dynamic IPv6SG, make sure DHCPv6 snooping operates correctly on the network.
To enable the IPv6SG feature on an interface:
Step
1. Enter system view.
2. Enter interface view.
3. Enable the IPv6SG
feature.

Configuring a static IPv6SG binding

Step
1. Enter system view.
Command
system-view
interface interface-type
interface-number
ip source binding { ip-address
ip-address | ip-address
ip-address mac-address
mac-address | mac-address
mac-address } [ vlan vlan-id ]
Command
system-view
interface interface-type
interface-number
ipv6 verify source
{ ip-address | ip-address
mac-address | mac-address }
Command
system-view
517
Remarks
N/A
The following interface types are
supported:
•
Layer 2 Ethernet port.
•
VLAN interface.
By default, no static IPv4SG binding is
configured on an interface.
The vlan vlan-id option is supported only
in Layer 2 Ethernet interface view.
You can configure the same static
IPv4SG binding on different interfaces.
Remarks
N/A
The following interface types are
supported:
•
Layer 2 Ethernet port.
•
VLAN interface.
By default, the IPv6SG feature is disabled
on an interface.
If you configure this command on an
interface multiple times, the most recent
configuration takes effect.
Remarks
N/A