Password Authentication Enabled Stelnet Client Configuration Example - HP MSR Series Configuration Manual

g. Click Open to connect to the server.
If the connection is successfully established, the system notifies you to enter the username.
After entering the username (client002), you can enter the CLI of the server.
Password authentication enabled Stelnet client configuration
example
Network requirements
As shown in
•
Router B acts as the Stelnet server and uses password authentication.
•
The username and password of the client are saved on Router B.
Establish a connection between Router A and Router B, so you can log in to Router B to manage
configurations.
Figure 125 Network diagram
Configuration procedure
1. Configure the Stelnet server:
# Generate RSA key pairs.
<RouterB> system-view
[RouterB] public-key local create rsa
The range of public key size is (512 ~ 2048).
If the key modulus is greater than 512, it will take a few minutes.
Press CTRL+C to abort.
Input the modulus length [default = 1024]:
Generating Keys...
........................++++++
...................++++++
..++++++++
............++++++++
Create the key pair successfully.
# Generate a DSA key pair.
[RouterB] public-key local create dsa
The range of public key size is (512 ~ 2048).
If the key modulus is greater than 512, it will take a few minutes.
Press CTRL+C to abort.
Input the modulus length [default = 1024]:
Generating Keys...
.++++++++++++++++++++++++++++++++++++++++++++++++++*
........+......+.....+......................................+
...+.................+..........+...+
Create the key pair successfully.
# Enable the Stelnet server.
Figure 125:
417