Is-Is Authentication Configuration Example - HP MSR Series Configuration Manual

T2 Timer Status:
Remaining Time: 59
IS-IS(1) Level-2 Restart Status
Restart Interval: 150
SA Bit Supported
Total Number of Interfaces = 1
Restart Status: RESTARTING
Number of LSPs Awaited: 3
T3 Timer Status:
Remaining Time: 140
T2 Timer Status:
Remaining Time: 59

IS-IS authentication configuration example

Network requirements
As shown in
domain.
Router A, Router B, and Router C belong to Area 10, and Router D belongs to Area 20.
Configure neighbor relationship authentication between neighbors. Configure area authentication in
Area 10 to prevent untrusted routes from entering into the area. Configure routing domain authentication
on Router C and Router D to prevent untrusted routes from entering the routing domain.
Figure 46 Network diagram
Configuration procedure
1. Configure IP addresses for interfaces. (Details not shown.)
2. Configure IS-IS basic functions:
# Configure Router A.
<RouterA> system-view
[RouterA] isis 1
[RouterA-isis-1] network-entity 10.0000.0000.0001.00
[RouterA-isis-1] is-level level-1
Figure 46, Router A, Router B, Router C, and Router D reside in the same IS-IS routing
160