To install the power adapter, connect the power adapter to the power adapter connector at the rear of your
computer and a workable electrical outlet.
Figure 16. Connecting the power adapter
Replacing the computer stand
Attention: Do not open your computer or attempt any repair before reading and understanding the Chapter
1 "Read this first: Important safety information" on page 1.
To replace the computer stand, refer to the following topics:
•
"Replacing the frame stand" on page 89
•
"Replacing the monitor stand" on page 90
•
"Replacing the UltraFlex II Stand" on page 92
Replacing the frame stand
To replace the frame stand, do the following:
1. Remove any media from the drives and turn off all connected devices and the computer. Then,
disconnect all power cords from electrical outlets and disconnect all cables that are connected to the
computer.
2. Place a soft, clean towel or cloth on the desk or surface. Hold the sides of your computer and gently lay
it down so that the screen is against the surface and the computer cover is facing up.
.
Chapter 9
Installing or replacing hardware
89