Door Switch - Vulcan-Hart VC4G Service Manual

VC4G & VC6G SERIES FULL SIZE CONVECTION OVENS - REMOVAL AND REPLACEMENT OF PARTS
Fig. 45
2. Independent doors:
A. Remove the door handle then remove the
outer door panel.
B. Lift out the inner door panel and window
assembly.
NOTE: Left door only - remove door seal from the
inside edge of the door.
3. Simultaneous doors:
A. If replacing window on the left door, remove
the handle from the front of the door then
remove door seal from the inside edge of the
door.
1) Lift out the inner door panel and
window assembly.
2) If replacing window on the right door,
remove the screws along the inside
edge (if applicable) of the door then
remove the inner door panel and
window assembly.
4. Remove the screws securing the window "tabs"
to the door bracket and lift the window assembly
out from the door frame.
F24682 Rev. D (1016)
5. Reverse procedure to install the replacement
window.
1. Remove the Top Front Cover.
2. Disconnect the lead wires to the door switch.
3. Remove the switch.
Page 20 of 75
Fig. 46

DOOR SWITCH

Disconnect the
electrical power to the machine and
follow lockout / tagout procedures.