Paxar TC6037PR Reference Manual page 101

751 Printer did not sense a black mark when expected. The supply
may be jammed.
For these errors, Check the
¨
supply tracking
¨
supply marks
¨
black mark sensor position
¨
supply roll for binding.
If the error continues to appear, change the supply.
752 Printer sensed a mark in the wrong place.
753 Printer sensed a mark that is too long.
756 The printer is out of supplies. Load supplies.
757 Load supplies. The calibrated supply length differs by plus or
minus 0.25 inches from the format.
758 Check supply. Either the supply is not seen, or the on-demand
sensor is broken (purchase optional). Check for a label jam.
Clear the supply path or reload supplies. This error may occur if
you remove a label too quickly in on-demand mode. The printer
does not recalibrate after this error.
762 Low battery. Recharge the battery.
763 Waiting to dispense label.
765
Printhead has less than 3 bad dots.
768
Printhead has more than 10 bad dots or is not connected. Make
sure the printhead is connected.
790 The printer is busy. Turn off the printer. Wait two seconds and
turn it back on. Resend the packets. If the problem continues,
call Technical Support.
791 The printer has an error pending. Turn off the printer. Wait two
seconds and turn it back on. Resend the packets. If the problem
continues, call Technical Support.
Troubleshooting 6-15