Saving A Switch Dump - IBM RackSwitch G8000 Application Manual

Saving a Switch Dump

© Copyright IBM Corp. 2011
3. If you are using an FTP server, enter a username:
Set agTransferUserName.0 "MyName"
4. If you are using an FTP server, enter a password:
Set agTransferPassword.0 "MyPassword"
5. Initiate the transfer. To save a running configuration file, enter 4:
Set agTransferAction.0 "4"
To save a switch dump to a FTP/TFTP server, follow these steps. This example
shows an FTP/TFTP server at 192.168.10.10, though IPv6 is also supported.
1. Set the FTP/TFTP server address where the configuration will be saved:
Set agTransferServer.0 "192.168.10.10"
2. Set the name of dump file:
Set agTransferDumpFileName.0 "MyDumpFile.dmp"
3. If you are using an FTP server, enter a username:
Set agTransferUserName.0 "MyName"
4. If you are using an FTP server, enter a password:
Set agTransferPassword.0 "MyPassword"
5. Initiate the transfer. To save a dump file, enter 5:
Set agTransferAction.0 "5"
Chapter 27. Simple Network Management Protocol
329