Ospf Features Not Supported In This Release; Ospfv2 Configuration Examples - IBM RackSwitch G8000 Application Manual

OSPF Features Not Supported in This Release

OSPFv2 Configuration Examples

270
RackSwitch G8000: Application Guide
To enable OSPF on an existing loopback interface:
RS G8000(config)# interface loopback <1-5>
RS G8000(config-ip-loopback)# ip ospf area <area ID> enable
RS G8000(config-ip-loopback)# exit
The following OSPF features are not supported in this release:
• Summarizing external routes
• Filtering OSPF routes
• Using OSPF to forward multicast routes
• Configuring OSPF on non-broadcast multi-access networks (such as frame relay,
X.25, or ATM)
A summary of the basic steps for configuring OSPF on the G8000 is listed here.
Detailed instructions for each of the steps is covered in the following sections:
1. Configure IP interfaces.
One IP interface is required for each desired network (range of IP addresses)
being assigned to an OSPF area on the switch.
2. (Optional) Configure the router ID.
The router ID is required only when configuring virtual links on the switch.
3. Enable OSPF on the switch.
4. Define the OSPF areas.
5. Configure OSPF interface parameters.
IP interfaces are used for attaching networks to the various areas.
6. (Optional) Configure route summarization between OSPF areas.
7. (Optional) Configure virtual links.
8. (Optional) Configure host routes.