Variable Definitions - Avaya 3500 Quick Start Configuration

Connecting to the switch
If you ran the install script to set up the configuration information, the read-only
community name is already configured.
4. Configure the read-write community name:
snmp-server community rw
Note:
Enter the community string twice.
If you ran the install script to set up the configuration information, the read-write
community name is already configured.
5. Configure the system name:
snmp-server name <text>
6. Configure the system contact:
snmp-server contact <text>
7. Configure the location:
snmp-server location <text>
8. Configure the SNMP host to add a trap receiver to the trap-receiver table:
snmp-server host <host-ip> <community-string>

Variable definitions

Use the definitions in the following table to use the snmp-server name command.
Table 1: snmp-server name command
Variable
<text>
Use the definitions in the following table to use the snmp-server contact command.
Table 2: snmp-server contact command
Variable
<text>
September 2016
Definition
Specify the SNMP system name value. Enter an
alphanumeric string of up to 255 characters.
Note:
On the console, the SNMP server name is
truncated. On the web interface, the full SNMP
server name appears.
Definition
Specify the SNMP system contact value. Enter an
ASCII string of up to 255 characters.
Quick Start Configuration
Comments on this document? infodev@avaya.com
38